JeffKenworthy
2009-10-26T17:10:00Z
There is what seems to be a black mould growing in the crevices of the non-slip pattern moulded into the deck surface. Scrubbing doesn't remove it. It can be scraped out with a sharp tool but that is extremely tedious and probably leaves small scratches which help it adhere in future. Is there a better method?
Geoff Harwood
2009-10-27T08:51:31Z
I have the same thing on mine! I'd tried to scrub it off and when that didn't seem to be effective I assumed it was some kind of wear that had worn off the gelcoat off the bumps. I had resigned myself to a coat of deck paint!

Your note prompted a closer look. Most of it is, as you suggest, a kind of algae and can be poked out with a pin. Tedious! An old toothbrush doesn't touch it. If you give it a good soak first, a brand new toothbrush does winkle it out. It will still take a while to do the whole deck but it beats a pin. Maybe there's a bigger brush that has thin stiff pointy bristles like a new toothbrush.

UserPostedImage

Then there's another type of blackdots. These seem to be little round holes in the tops of the bumps which must be a defect in the first layer of gelcoat that went onto the mould. I can't think of a way of getting them to be less conspicuous. They are luckily much rarer than the algae spots and on my boat only in one place (deck between the mast and the hatch)

UserPostedImage

Geoff Cygnus P21/30

Simon Barker
2011-02-19T17:32:45Z
I too had this "black dot" problem on some non-slip surface areas on my P235 and tried gentle scrubbing etc. but to no avail. I went to the Boat Show last month and found the Marineglaze stand and purchased a bottle of their A-Glaze Deck Cleaner which is intended for use on non-slip moulded GRP decking. Have now tried it and it worked a treat - it removed all the black dots with very little effort on my part. They have a web site at www.marineaglaze.com  and it's not too expensive to buy.[:D]
JeffKenworthy
2011-02-23T14:20:15Z
Thank you for this tip - I'll try it.

I wonder why I never thought of trying a proprietary product.