Can anyone tell me the approx headheight in the galley and saloon please

Thanks for reading

The headroom is about 5ft.8ins in the saloon.

Regards

Denis

P27/158

I suspect this is optimistic.

It was this more than the headroom that caused me to reject the Seal 26.

Even the 27's loo doesn't fit my ideal in that my foul weather gear needs to come off before entry...

As for actual headroom, I'm just over 5'9"tall [short?], say >5'10" in footwear- all I can say is that I'm never conscious of having to stoop in the galley area, or of scraping my head, but the reality is that, except when standing at the galley, I don't spend much time just standing around in the saloon!

I'm usually automatically ducking and twisting to get something from the shelves or lockers, or to pass through to the loo or the forecabin.

What I really do appreciate though is the 6'6" long single quarter berth that lets me lie stretched out on my front, toes extended!

Geoff Sheddick

Parker 27/146 "Stroller'

Cheers! Ken

Ken Surplice

Commodore

Responding to Geof... getting into head..

Regarding the door on the head. Take it off the boat to a good table saw then simply cut it in half..top to bottom. Find a nice long brass hinge to fit length of your door half...lay out on the front(cabin) side and slide together tightly and tape tight (you can't see the cut on the front side if you had a good sharp saw blade). Screw hinge to both halves replace door, and now when you want to enter the head ....open door and push left.... door will split open easily and allow you to open and close by it's fold.

I can't tell you how many times I have seen big guys use the head with surprise as to how easy they get in, close door, do their business and then open door...just allow it to fold and then step out.

Just remember the hinge lays/screws exactly centered on your cut on the inside (head side) it doesn't have to be super long--leave 4 inches from top to bottom is ok.

I can try to get a picture for you if you give me a site to send .

Hope that helps,

Marvin Kowalewski

Parker 27 #138 The Happy Seal

Marvin Kowalewski, Ph.D

Sounds really great! But what do you do to keep the two door sections from falling into a V shape when you want them to stay in the Closed position? [whether you're inside or outside...]

sincerely

Geoff Sheddick

Parker 27/146 "Stroller'

Chris.

Not everything Bill Parker did was an improvement!

Good question....

I dunno...never happened... it just stays closed if you close it (latched)..or it stays against the keel wall (open)with the little spinner closure.

It's a nice easy job but do use a very good blade on a table saw...test for rip before you do the door. I found that if I layed the door face down on the table saw.. the hinge covered any small rip. Do protect the door as it lays on the table.

Marv

Marvin Kowalewski, Ph.D

I've realised that I made a wrong assumption, & failed to understand that the hinge goes on the Inside of the door!

Geoff Sheddick

Parker 27/146 "Stroller'